Gas Forge Triple Burner Set, Propane Forge Blacksmith Knife Making--

Description

All parts is made of Stainless steel .  Highly resistant to corrosion compared to other metals.  This is not made from hardware store plumbing parts .
The kit including:
1:    Adjustable High Pressure Propane Regulator 0--30 psi , 5 ft long (150cm).  The male end connects a standard size propane USA  QCC-1/Type-1 tank and the female end attaches to a 5/8'' flare fitting.
Fit with USA, Canada, Mexico, Australia propane tank.
2:
we use
3/4'' thread  feed tube(8"=20cm long,1'' O.D.) and outer diameter 2"  air choke  allow for maximum air flow,  with a proper size gas port tuned to produce higher btu's with less propane ,  this design is more efficient and saves you money on propane cost , and can run at lower gas pressure and produces a NEUTRAL flame with no need to adjust air flow , the burner is self adjusting and drafts the proper amount of air based on gas pressure .
3: flame cone on the bottom is 1-15/16"(48.5mm) Outer diameter wide, more enough heat for medium size forge..