KAWASAKI ZX10R ZX14 ZX14R NITROUS SPRAYBAR SYSTEM & 2.5lb. Bottle 30hp-150hp NOS

Description

Kawasaki zx14 zx14r zx10r zx6r Spraybar Nitrous system.
(We have them for other makes and models,just message us)
FREE SHIPPING TO ALL 50 STATES
Your choice of 3 jet sizes. 30hp-150hp jet choices.
Comes with a 2.5LB Gloss black Nitrous bottle and the complete kit as listed at the bottom of the page.
Sting the competition with this BADASS Spraybar Nitrous Kit. This kit is the MOST complete kit available. Made for high horsepower 4 cyl bikes, this kit will flow up to 150hp. Finally a complete kit made for any fuel injected 4 cyl motorcycle.
Custom fit your spray bar to your preference! Simply install the spraybar, bend your tubing, cut to length and your done.
This kit is the ultimate in tuneablity. Designed for use with or without progressive controllers, this kit jets at the spray bar and at the solenoid for tons of fine tuning ability.
Other spray bars do not work with progressive controllers due to poor design. if you mount jets at the spray bar, all the braided line and inside the spray bar acts like a reservoir holding the pressure. It will not pulse the pressure as it would take a second or two to bleed past the jets.
By jetting at the solenoid the pressure will build much slower in the lines giving way more control of the nitrous coming out of the hole.
Jet changes are now a snap! No more lifting the tank, simply swap the one jet on the solenoid.
Comes complete with a tubing bender, tubing cutter, extra tubes, jets, spray bar, braided lines, the list goes on and on.
NOTE: This kit requires the use of a programmable fuel device like a power commander or bazzaz. You must have the nitrous system professionally tuned before you use the nitrous!
Kit comes with:
•spray bar with spacers and mounting bolt
•150hp nitrous solenoid
•solenoid bracket
•your choice of 3 jet sizes 10hp-150hp
•8 stainless bendable tubes 12" long each
•4 tube nuts and sleeves
•1 foot -3an to -3an braided line to spray bar
•2 foot -3an to -3an braided line from solenoid
•4 foot -4an to -4an braided feed line from bottle
•electrical kit with wire, arming switch, etc
•Black 2.5lb nitrous bottle with siphon
•2.5lb stainless bottle brackets. qty 2
•tubing bender and tubing cutter
•-3an bulkhead fitting
Any questions feel free to ask.