Propane blacksmith/knife forge. 250 sold

Description

This a nice working forge for your next project. The chamber is 1 3/8" wide by
2 1/4" high and runs thru for the length of the forge which is 9".
It has a K26 insulating brick ( good to 2600 degrees ) and is wrapped in 18
gauge steel. A real propane gas sipper, a standard 20# propane tank
should last over 30 hours working time plus or minus 3 hours depending
on how high of a pressure you are running.
In the 3rd photo is a HC RR spike that was heated for 4 minutes with a
setting on the pressure regulator of
only 6 lbs. The fourth photo is a RR
spike knife I made.
Comes complete with a  Mr Heater 0-20 lb regulator, 0-30 lb gauge,
Mr Heater
5 foot hi pressure hose, a brass needle valve to fine tune
your flame plus the burner assembly and a tool rest.
It's ready to plug and
play,
all you need is a propane tank.
A lot of my forges are sold at blacksmith events.
I have these forges in 46 of the 51 states which
includes Alaska and Hawaii.
Made in the USA.
Do not use a flux as it will ruin/eat up the K26 brick.
Ship to USA states only.
Over 250 sold.